Triple Ten™

A liquid fertiliser representing state of the art fusion – utilising the best of both worlds, conventional and organic.

Triple Ten™ (10-10-10) is a liquid fertiliser combining a hot mix NPK blend, chelated trace elements and natural growth promotants. These natural growth promotants include fulvic acid, seaweed fertiliser and vitamins. Triple Ten™ represents state of the art fusion fertilising.

Benefits

– Improve yield & quality.

– Healthy, vigorous growth.

– Additional amino acids & chelated trace
elements.

Typical Analysis (W/V)

• Total Nitrogen (N) 10.48%
• Nitrogen (as urea) 5.75%
• Nitrogen (as ammonium) 4.20%
• Nitrogen (as organic) 0.53%
• Total Phosphorus (P) (water soluble) 10.23%
• Total Potassium (K) 10.69%
• Potassium (as phosphate) 10.20%
• Potassium (as organic) 0.42%
• Potassium (as hydroxide) 0.05%
• Potassium (as silicate) 0.02%
• Sulfur (S) 0.22%
• Iron (Fe) 1459 mg/L
• Zinc (Zn) 743 mg/L
• Manganese (Mn) 607 mg/L
• Calcium (Ca) 558 mg/L
• Boron (B) 347 mg/L
• Selenium (Se) 198 mg/L
• Copper (Cu) 197 mg/L
• Molybdenum (Mo) 39 mg/L
• SG 1.3
• pH 7 – 8
• Conductivity 80 – 100 mS/cm
• Appearance Thin black liquid

Application Rates

Foliar Spray:

Vegetables
1 L per 100 L water up to 5 L/ha equivalent
Apply weekly or as required

Orchards & Vineyards
1 L per 100 L water up to 7 L/ha equivalent
Apply every 2 – 4 weeks or as required

Ornamentals & Turf
1 L per 100 L water up to 5 L/ha equivalent
Apply every 2 – 4 weeks or as required

Broadacre Crops
1 – 3 L/ha in 60 – 100 L water depending on canopy
closure, apply as required

Pasture
1 – 3 L/ha in 60 –100 L water, apply as required

Spot-Spraying

50 mL per 10 L water, apply as required

Fertigation:

Vegetables
5 – 20 L/ha, apply weekly or as required

Orchards & Vineyards
5-20 L/ha, apply every 2 – 4 weeks or as required

Ornamentals
5 – 20 L/ha, apply every 2 – 4 weeks or as required
(not on P-sensitive native)

Turf
5 – 10 L/ha, apply every 2 – 4 weeks or as required

Home Garden Application:

Dilute 30 mL per 9 L watering can and apply the
diluted mix at a rate of 1 litre per square metre.
Apply fortnightly or as required.

Instructions  

Shake or stir well before use. Where higher water rates are required
for good foliar coverage, do not exceed maximum product rate per
hectare. Sensitive foliage or plants should be test sprayed prior to
full scale application. Frequencies are a guideline only and can be
adjusted according to farm practices and/or in conjunction with
crop monitoring. Ensure suitable spray conditions (e.g. temperature,
humidity, wind-speed), prior to foliar application. Compatibility and/
or performance cannot be guaranteed when combined with other
products. Jar test for compatibility and spray test on small area before
wide-spread use.

Important

– Avoid spraying close to harvest if produce is susceptible to staining.

– Not compatible with soluble calcium based inputs.

– Do not foliar spray until seedlings are 15 cm high.

– Note: Product in 1000 L tanks may weigh over 1 tonne. Forklift with
2 tonne lifting capacity is recommended.

– Note: Our Triple Ten™ formulation is identical for all crop specific
products (with the exception of Citrus-Tech Triple Ten™). The
individual labels relate to different application rates and timings
that are critical to the success of the product.

Storage & Handling

• • * Warning: This fertiliser contains biuret, maximum 0.18%.
    Repeated foliar sprays may cause damage to citrus. For citrus use
    Citrus-Tech Triple Ten™.
  • – Store in a cool dry area out of direct sunlight. This product
    has been tested to store safely down to 5ºC. Crystallisation or
    sedimentation may occur below 5ºC.

– Do not pre-mix or store in
diluted form. Seal lid/cap immediately after use.